Perkins 1106 — Engine Valve Lash - Inspect/Adjust
Adjustments · valve train
For the Perkins 1106, from the Perkins service manual.
Applies to: Perkins 1106
Procedure
- Remove valve mechanism cover.
- Rotate crankshaft until No. 6 cylinder inlet valve opened and exhaust valve not fully closed (TC compression).
- Measure valve lash for valves according to Table 5.
- Adjust if necessary: loosen locknut, place feeler gauge, turn adjustment screw.
- Rotate crankshaft to TC exhaust stroke (360 from TC compression).
- Measure valve lash for valves according to Table 6.
- Adjust if necessary.
- Install valve mechanism cover.
Tools required
- Feeler gauge Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Inlet valve lash 0.20 mm
- Exhaust valve lash 0.45 mm
Full service-parts list: Perkins 1106 →
Source: Perkins service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.