Perkins 1106 — Aftercooler Core - Clean/Test
Maintenance
For the Perkins 1106, from the Perkins owner's manual.
Applies to: Perkins 1106
Before you start
- Personal injury can result from air pressure.
Procedure
- Remove the core.
- Turn the aftercooler core upside-down to remove debris.
- Use pressurized air opposite the fan air flow to remove loose debris.
- Pressurized water may be used to soften mud; clean the core from both sides.
- Back flush the core with a suitable cleaner.
- Steam clean the core and flush the fins; remove any other trapped debris.
- Wash the core with hot, soapy water and rinse thoroughly with clean water.
- Dry the core with compressed air in the reverse direction of normal flow.
- Inspect the core for cleanliness and pressure test it; repair if necessary.
- Install the core.
- Start the engine and accelerate to high idle to remove debris and dry the core, then stop the engine.
Specs & values
- Maximum air pressure at the nozzle less than 205 kPa (30 psi)
- Maximum water pressure less than 275 kPa (40 psi)
Full service-parts list: Perkins 1106 →
Source: Perkins owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.