Perkins 1104D — Water Pump - Install
Maintenance
For the Perkins 1104D, from the Perkins service manual.
Browse Perkins generators & specs →
Procedure
- Ensure water pump clean and free from wear or damage; replace if necessary.
- If necessary, install cover to water pump: clean cover surface, position new joint, install cover, install bolts finger tight.
- Clean mating surface of front cover.
- Install guide studs in position.
- Use guide studs to align new joint to front cover; install joint.
- Align water pump with guide studs; install to front cover.
- Install bolts finger tight.
- Remove guide studs and install remaining bolts finger tight.
- Tighten bolts to 22 N·m (16 lb ft) in sequence.
- Install hose to water pump inlet; tighten hose clamps.
- Fill cooling system with coolant.
Tools required
- Guide Stud (M8 by 80 mm) Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- 22 N·m (16 lb ft)
Source: Perkins service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.