Perkins 1104 — Flywheel - Install
Maintenance
For the Perkins 1104, from the Perkins service manual.
Applies to: Perkins 1104, Perkins N H1 (Engine) engine
Before you start
- Always wear protective gloves when handling parts that have been heated.
Procedure
- If ring gear removed, install new ring gear: identify orientation, heat in oven to max 250 °C (482 °F), install quickly.
- Inspect crankshaft rear seal for leaks; replace if leaking.
- Install suitable lifting device to flywheel.
- Install guide studs to crankshaft.
- Position flywheel onto guide studs.
- Install bolts finger tight.
- Remove guide studs and install remaining bolts.
- Remove lifting device.
- Use suitable tool to prevent flywheel rotation; tighten bolts to 120 N·m (88 lb ft).
- Check run out of flywheel.
Tools required
- Guide Stud (1/2 inch - 20 UNF by 4 inch) Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- 120 N·m (88 lb ft)
- 250 °C (482 °F)
Full service-parts list: Perkins 1104 →
Source: Perkins service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.