Northern Lights M844LW3 / M844W3 — Make rear panel connections (exhaust, water, fuel, DC, battery, AC)
Installation · Rear panel penetrations
For the Northern Lights M844LW3 / M844W3, from the Northern Lights service manual.
Applies to: Northern Lights M844LW3, Northern Lights M844W3
Procedure
- Push the two inch hose onto the exhaust connection pipe protruding through the left mid-section of the rear panel.
- Push a 3/4 inch hose from the seawater strainer through the lower left hole to the sea water pump inlet fitting.
- Connect fuel supply and fuel return using Coast Guard approved rubber fuel hoses at the forward right side couplings.
- Connect the DC control harness to the engine harness plug through the mid-section hole on the right side.
- Connect the 12 volt battery leads through the second hole above the bottom left side.
- Connect the AC output leads through the top hole on the right side of the rear panel.
Full service-parts list: Northern Lights M844LW3 →, Northern Lights M844W3 →
Source: Northern Lights service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.