Northern Lights M753 / M753W2 — Oil Changes
Maintenance · Engine lubrication system
For the Northern Lights M753 / M753W2, from the Northern Lights operator's manual.
Applies to: Northern Lights M753, Northern Lights M753W2
Before you start
- Never use flushing oil.
- Dispose of waste oil in approved manner.
Parts for this job
- 140546020 Oil filter — Northern Lights M753 Amazon eBay
- 24-02001 Oil filter — Northern Lights M753W2 Amazon eBay $23.45 NAPA $9.09
Part numbers from the service-parts lists for Northern Lights M753, Northern Lights M753W2. Verify against your serial number before ordering; some links are affiliate links.
Procedure
- The set is delivered with special break-in oil; change engine oil and filter after 50 hours.
- Use Service CC 30 weight oil during the first 100 hours.
- Change oil and filter again at 100 hours using oil in Figure 8; then every 250 hours.
- During intermittent cold weather, change oil every 100 hours or six weeks, whichever comes first.
- Change oil at seasonal temperature changes when new viscosity is required; change when engine is warm.
- Loosen clamp on oil change tube, remove cap, drain oil, replace cap and tube.
- Refill with recommended oil.
Specs & values
- 753W oil capacity with new filter: 3.7 quarts (3.5 liters).
- 753W2 oil capacity with new filter: 4.75 quarts (4.5 liters).
- Break-in oil: Service CC 30 weight during first 100 hours.
Full service-parts list: Northern Lights M753 →, Northern Lights M753W2 →
Source: Northern Lights operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.