Northern Lights M753 / M753W2 — Changing Lube Oil Filter

Maintenance

For the Northern Lights M753 / M753W2, from the Northern Lights operator's manual.

Applies to: Northern Lights M753, Northern Lights M753W2

Procedure

1. Change lube oil filter every 250 hours.
2. Use a filter wrench to remove old filter; dispose in approved manner.
3. Remove and discard old gasket; clean mount face.
4. Spread thin film of engine oil on new filter rubber gasket; screw on until gasket meets sealing surface.
5. Tighten one-half turn farther by hand only; do not overtighten.
6. Fill engine with recommended oil; start and check for leakage.
7. Stop engine, wait 3 minutes, and check oil level; add if necessary.

Full service-parts list: Northern Lights M753 →, Northern Lights M753W2 →

Source: Northern Lights operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Northern Lights repair guides →