Northern Lights M175C2 — Lube Oil Filter Change
Maintenance
For the Northern Lights M175C2, from the Northern Lights operator's manual.
Applies to: Northern Lights M175C2
Before you start
- Overtightening can damage filter housing.
Parts for this job
Part numbers from the service-parts list for Northern Lights M175C2. Verify against your serial number before ordering; some links are affiliate links.
Procedure
- Remove old filter with filter wrench and discard.
- Remove and discard old filter gasket.
- Lubricate new filter rubber gasket.
- Screw filter on until gasket meets sealing surface.
- Tighten by hand one-half turn farther.
- Fill engine with oil, start, check for leaks, and check level.
Tools required
- filter wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Northern Lights M175C2 →
Source: Northern Lights operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.