Northern Lights M175C2 — Engine Oil Change
Maintenance · Engine lubrication system
For the Northern Lights M175C2, from the Northern Lights operator's manual.
Applies to: Northern Lights M175C2
Parts for this job
Part numbers from the service-parts list for Northern Lights M175C2. Verify against your serial number before ordering; some links are affiliate links.
Procedure
- Run engine five minutes to warm oil, then shut off.
- Remove base frame outlet plug and install drain hose.
- Open oil pan outlet valve and drain oil.
- Close valve, remove hose, and replace plug.
- Refill with recommended oil.
- Crank engine 30 seconds without starting to prelubricate.
- Start engine, check for leaks, stop, and check oil level after 10 minutes.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Engine lube oil capacity 30.1 qts (28.5 liters)
Full service-parts list: Northern Lights M175C2 →
Source: Northern Lights operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.