Northern Lights M1064H / M1066H — Operating
Operation · Generator set
For the Northern Lights M1064H / M1066H, from the Northern Lights operator's manual.
Applies to: Northern Lights M1064H, Northern Lights M1066H, John Deere Powertech Tier II 4045 engine, John Deere Powertech Tier II 6068 engine
Before you start
- If engine dies while under load, immediately remove load and restart engine.
Procedure
- Check gauges often. Oil pressure must be above 29 PSI; stop if not above 15 PSI within 5 seconds of starting.
- Normal oil pressure is 50 PSI at rated load speed (1800 to 2500 RPM).
- Oil temperature should be 115°C (240°F) for normal operating temperature.
- DC voltmeter should read 13 to 14 volts (26-28 volts for 24-volt systems).
- Check AC voltage and frequency meters; shut down and investigate if deviation.
- Check belt for good alignment.
- Run unloaded for three to five minute warm-up before applying load.
- Do not add full electrical load until engine is at maximum operating temperature.
Specs & values
- Oil pressure above 29 PSI
- Normal oil pressure 50 PSI at rated load speed
- Oil temperature 115°C (240°F)
- DC voltmeter 13-14 V or 26-28 V
Full service-parts list: Northern Lights M1064H →, Northern Lights M1066H →
Source: Northern Lights operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.