Northern Lights M1064H / M1066H — Changing Oil Filter
Maintenance
For the Northern Lights M1064H / M1066H, from the Northern Lights operator's manual.
Applies to: Northern Lights M1064H, Northern Lights M1066H, John Deere Powertech Tier II 4045 engine, John Deere Powertech Tier II 6068 engine
Before you start
- Overtightening can damage filter housing.
Parts for this job
- RE504836 Oil filter — Northern Lights M1064H Amazon eBay $44.99 NAPA $28.76 FridayParts $20.99
- RE504836 Oil filter — Northern Lights M1066H Amazon eBay $44.99 NAPA $28.76 FridayParts $20.99
Part numbers from the service-parts lists for Northern Lights M1064H, Northern Lights M1066H. Verify against your serial number before ordering; some links are affiliate links.
Procedure
- Use filter wrench to remove old filter; dispose in approved manner.
- Make sure old filter gasket is removed and discarded.
- Lubricate rubber gasket on new filter and screw on until gasket meets sealing surface.
- Using hands only, tighten filter one-half turn farther.
- Fill engine with recommended oil; start and check for leakage.
- Stop engine and check oil level; add oil if necessary.
Tools required
- Filter wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Northern Lights M1064H →, Northern Lights M1066H →
Source: Northern Lights operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.