Northern Lights L6125 — Starting
Operation · Engine
For the Northern Lights L6125, from the Northern Lights operator's manual.
Applies to: Northern Lights L6125, Northern Lights L6125H engine
Before you start
- Do not crank starter for more than 15 seconds consecutively.
- Never race a cold engine.
Procedure
- Put gear control in neutral.
- Move throttle control to idle position.
- Turn key switch to first position; voltmeter should not read below 24 volts.
- Turn key to starting position; release key as soon as engine starts.
- Move throttle up until engine runs at approximately 1000 RPM.
- Do not crank starter more than 15 seconds consecutively.
- Operate at 1000 RPM for a 3 to 5 minute warm-up period.
Specs & values
- Voltmeter should not read below 24 volts for starting
- Warm-up at 1000 RPM for 3 to 5 minutes
Full service-parts list: Northern Lights L6125 →
Source: Northern Lights operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.