MTU — Installing crankshaft
Installation
From a MTU service manual covering: 12V2000, 12V2000M60, 12V2000M70, 12V2000M80, 12V2000M90, 12V2000M91, 16V2000, 16V2000M60, 16V2000M70, 16V2000M80, 16V2000M90, 16V2000M91. Check it applies to your exact model before use.
Applies to: MTU 16V2000
Before you start
- Suspended load. Risk of injury! Use suitable tools and lifting equipment. Never stand beneath a suspended load.
Procedure
- Wipe crankshaft bearing surfaces; inspect oil bores with lamp.
- Insert four assembly screws on first and last bearing to protect crankshaft.
- Lift crankshaft with rope slings and crane.
- Align crankshaft horizontally and vertically with line of bores in crankcase.
- Ensure markings on crankshaft gear and camshaft gear are aligned.
- Carefully lower crankshaft into bearing shells.
- Remove assembly screws.
- Do not rotate crankshaft until axial alignment bearing has been installed.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: MTU 16V2000 →
Source: MTU service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.