MTU 8V 2000 C / 8V 2000 G — Installing crankshaft
Installation · Crankshaft / crankcase
For the MTU 8V 2000 C / 8V 2000 G, from the MTU service manual.
Browse MTU generators & specs →
Before you start
- Suspended load – risk of injury; never stand beneath a suspended load
Procedure
- Wipe crankshaft bearing surfaces and inspect oil bores.
- Insert four assembly screws on first and last bearing.
- Lift crankshaft with rope slings and crane.
- Align crankshaft horizontally and vertically with line of bores.
- Ensure markings on crankshaft gear and camshaft gear are aligned.
- Carefully lower crankshaft into bearing shells.
- Remove assembly screws.
- Do not rotate crankshaft until axial alignment bearing is installed.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: MTU service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.