Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Changing Engine Oil, Oil Filters and Bypass Oil Filter

Mitsubushi ST2R-Y1IPTA. — Changing Engine Oil, Oil Filters and Bypass Oil Filter

For the Mitsubushi ST2R-Y1IPTA..

Browse Mitsubushi generators & specs →

Before you start

  • To drain oil or change oil filters, wear gloves - hot engine oil and parts may cause burns
  • When changing engine oil, change the oil filters and bypass oil filter at the same time
  • It is recommended to analyze engine oil properties at the same time
  • Change the oil filters whenever the filter alarm turns on
  • Do not suck out the engine oil when draining

Procedure

  1. To ensure thorough drainage, drain engine oil while it is still warm after engine operation
  2. Clean the area around the oil filters
  3. Place an oil-receiving tray under the oil filters
  4. Using the provided filter wrench, remove each oil filter
  5. Check the filter elements in the removed oil filter for metal particles
  6. If metal particles are found, consult a Mitsubishi dealer
  7. Wipe oil from the oil filter mounting surface on the filter bracket with a cloth
  8. Check the new oil filter for proper seating of the gaskets
  9. Apply clean engine oil to the gaskets on the new oil filter
  10. Install the oil filter - when the gasket contacts the mounting surface on the filter bracket, further rotate 3/4 to a full turn

Tools required

  • oil filter wrench
  • gloves

Specs & torque values

  • new oil filters
  • bypass oil filter

Source: manual:Mitsubishi S12R-Y1PTA Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.