Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Lubricating system periodic inspection and mainte- nance

Mitsubushi — Lubricating system periodic inspection and mainte- nance

A Mitsubushi service procedure — check it applies to your exact model before use.

Browse Mitsubushi generators & specs →

Before you start

  • For engine oil, refer to "ENGINE OIL" (5-1) .
  • Disassemble the removed oil filter and bypass
  • Sucking-up draining should be avoided.

Procedure

  1. Clean the area around the oil filters.
  2. Piace a drip pan under oil filters and a bypass oil
  3. Using a filter wrench, remove oil filters and a *
  4. Wipe off oil on the oil filter mounting surface of the
  5. Check new oil filters and a bypass filter for proper
  6. Apply clean engine oil to the gaskets on new oil fil-
  7. Install oil titers and a bypass oil filter. When the
  8. Reinstall the drain plug.
  9. Remove the oil filler cap.
  10. Fill the engine oil pan with specified engine oil to z
  11. Check the oil level in the oil pan as follows: Fig.8-13 Oil filler and oil level gage
  12. If the oil level is low, add engine oil of the specified
  13. Shut off the fuel supply and crank the engine for
  14. Perform the above cranking operation again to cir-
  15. Check the oil level with the oil level gauge again,

Tools required

  • the oil level gauge again,
  • guide, then pull the gauge out again
  • a filter wrench, remove oil filters and a *

Source: manual:Mitsubishi S16R-Y1PTA-2 Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.