Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Mitsubishi›Remove the engine from storage

Mitsubishi S6R S6R2 / S6R- S6R2 — Remove the engine from storage

Maintenance

For the Mitsubishi S6R S6R2 / S6R- S6R2, from the Mitsubishi operator's manual.

Applies to: Mitsubishi S6R engine, Mitsubishi PS6 engine

Before you start

  • Crank with the fuel supply shut off to confirm oil pressure rises properly

Procedure

  1. Remove the covering from the engine.
  2. Connect well-charged batteries to the engine.
  3. Remove the covering from the starter and alternator.
  4. Adjust the fan drive belt and remove all covering and taping.
  5. Drain the rust preservative and fill with recommended engine oil.
  6. Fill the fuel tank and prime the fuel system.
  7. Check for loose or missing bolts and oil, fuel or coolant leaks.
  8. Remove the rocker covers and lubricate the valve mechanism.
  9. Crank the engine three times, 10 seconds each, at 1-minute intervals with fuel shut off.
  10. Start the engine and allow it to warm up at low idle, then apply load.

Source: Mitsubishi operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Mitsubishi repair guides →