Mitsubishi — Installing the External Hydraulic Adapter (Optional)
Installation · hydraulic case
From a Mitsubishi owner's manual — check it applies to your exact model before use.
Browse Mitsubishi generators & specs →
Before you start
- The implement must have a double action control valve.
Procedure
- Loosen the three bolts on the left side of the hydraulic case and remove the cap, taking care not to drop the O-ring.
- Fit the O-ring correctly to the hydraulic adapter and install it on the hydraulic case; tighten to 2.5~3.0 kg-m (18~22 ft-lb).
- Connect the adapter outlet, implement control valve inlet, control valve outlet and return port with pipes.
- Start the engine and bleed the cylinder and pipes using the implement control valve.
- Check the pipe joints for oil leakage.
Specs & values
- Tightening torque 2.5~3.0 kg-m (18~22 ft-lb)
Source: Mitsubishi owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.