Mitsubishi — Installing injection nozzle assemblies
Repair & overhaul
From a Mitsubishi service manual — check it applies to your exact model before use.
Applies to: Mitsubishi S16R engine
Before you start
- Fit gasket when installing nozzle assembly.
Procedure
- Remove fuel inlet connector from nozzle assembly.
- Fit three O-rings and apply grease.
- Apply grease to gasket and insert nozzle.
- Tighten fuel inlet connector to specified torque.
- Tighten nozzle gland nut to specified torque.
Specs & values
- Fuel inlet connector: 10 kgf-m (72 lbf-ft) [98 N-m]
- Nozzle gland: 6.5 to 7.5 kgf-m (47 to 54 lbf-ft) [64 to 74 N-m]
Full service-parts list: Mitsubishi S16R engine →
Source: Mitsubishi service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.