Mitsubishi — >>D<< CYLINDER HEAD BOLT INSTALLATION

A Mitsubishi service procedure — check it applies to your exact model before use.

Browse Mitsubishi generators & specs →

Procedure

1. 1. When the removed cylinder head bolts are to be
2. reused, check that the shank length of each bolt
3. meets the limit. If it exceeds the limit, replace the
4. bolts.
5. Limit: 99.4 mm
6. 2. Apply engine oil to the thread of the bolts and to
7. the washers.
8. 3. Using special tool Cylinder head bolt wrench
9. (800410) tighten the bolts to the specified torque,
10. using the tightening sequence shown.
11. Tightening torque: 78 ± 2 N·m
12. 4. Loosen all bolts fully in the reverse order of
13. tightening.
14. 5. Retighten the loosened bolts to in the tightening
15. sequence shown.

Source: manual:Mitsubishi-2.0L-2.4L-Service-Manual-106992-Revision-D.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.