Mitsubishi — TIMING BELT

A Mitsubishi service procedure — check it applies to your exact model before use.

Browse Mitsubishi generators & specs →

Procedure

1. 14. The wire inserted at the auto-tensioner
2. installation is pulled out and then the special tool
3. Set screw (800425) is removed by hand.
4. 15. Give two clockwise turns to the crankshaft.
5. Wait for 15 minutes, and then proceed with the
6. following inspection steps.

Source: manual:Mitsubishi-2.0L-2.4L-Service-Manual-106992-Revision-D.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.