Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›INSTALLATION

Mitsubishi — INSTALLATION

A Mitsubishi service procedure — check it applies to your exact model before use.

Browse Mitsubishi generators & specs →

Procedure

  1. 1. Using special tools to prevent the camshaft
  2. sprocket from rotating.
  3.  End yoke holder (800405)
  4.  Pulley holder pin (800406)
  5. 2. Tighten the camshaft sprocket bolt to the
  6. specified torque.
  7. Tightening torque: 88 ± 10 N·m
  8. 1. Apply a thin coat of clean engine oil to the lip
  9. area of the oil seal.
  10. 2. Install the spacer with the chamfered end facing
  11. toward the oil seal.

Tools required

  • 1. Using special tools to prevent the camshaft

Specs & torque values

  • 10 N·m

Source: manual:Mitsubishi-2.0L-2.4L-Service-Manual-106992-Revision-D.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.