Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›8. Remove the screwdriver inserted in step 4 and

Mitsubishi — 8. Remove the screwdriver inserted in step 4 and

A Mitsubishi service procedure — check it applies to your exact model before use.

Browse Mitsubishi generators & specs →

Before you start

  • NOTE: Use a torque wrench that can measure 0

Procedure

  1. 10. Install special tool Tension pulley socket
  2. wrench (800407), socket wrench and torque
  3. wrench, onto the tensioner pulley, and loosen the
  4. tensioner pulley center bolt.
  5. NOTE: Use a torque wrench that can measure 0
  6. to 5.0 N·m.
  7. 11. Torque to 2.5-2.6 N·m with the torque wrench.
  8. 12. Holding the tensioner pulley with special tool
  9. Tension pulley socket wrench (800407) and
  10. torque
  11. wrench
  12. tighten
  13. the
  14. center
  15. bolt
  16. to
  17. specification.
  18. Tightening torque: 48 ± 5 N·m

Tools required

  • 10. Install special tool Tension pulley socket
  • Tension pulley socket wrench (800407) and
  • NOTE: Use a torque wrench that can measure 0

Specs & torque values

  • 11. Torque
  • 5 N·m
  • 2.6 N·m

Source: manual:Mitsubishi-2.0L-2.4L-Service-Manual-106992-Revision-D.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.