Mitsubishi — >>G<< AUTO-TENSIONER INSTALLATION

A Mitsubishi service procedure — check it applies to your exact model before use.

Browse Mitsubishi generators & specs →

Procedure

1. 3. Insert a wire (1.4 mm in diameter) or a 1/16”
2. allen
3. wrench
4. into
5. the
6. set
7. holes.
8. This
9. auto-tensioner setting wire will be used during
10. timing belt alignment.
11. 4. Unclamp the auto-tensioner from the vise.

Source: manual:Mitsubishi-2.0L-2.4L-Service-Manual-106992-Revision-D.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.