Mitsubishi — AUTO TENSIONER

A Mitsubishi service procedure — check it applies to your exact model before use.

Browse Mitsubishi generators & specs →

Procedure

1. 1. Check for oil leaks. If oil leaks are evident,
2. replace the auto-tensioner.
3. 2. Check the rod end for wear or damage and
4. replace the auto-tensioner if necessary.
5. 3. Measure the rod protrusion. If it is out of
6. specification, replace the auto tensioner.
7. Standard value: 12 mm

Source: manual:Mitsubishi-2.0L-2.4L-Service-Manual-106992-Revision-D.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.