Mitsubishi — >>G<< AUTO-TENSIONER INSTALLATION

A Mitsubishi service procedure — check it applies to your exact model before use.

Browse Mitsubishi generators & specs →

Procedure

1. 1. Clamp the auto-tensioner in a vise with soft
2. jaws.
3. 2. Push in the rod little by little with the vise until
4. the set hole A in the rod is aligned with hole B in
5. the cylinder.

Source: manual:Mitsubishi-2.0L-2.4L-Service-Manual-106992-Revision-D.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.