Mitsubishi — >>F<< OIL PUMP SPROCKET INSTALLATION

A Mitsubishi service procedure — check it applies to your exact model before use.

Browse Mitsubishi generators & specs →

Procedure

1. 1. Insert a Phillips head screwdriver (shank
2. diameter 8 mm) through the plug hole on the left
3. side of the cylinder block to block the left
4. counterbalance shaft.
5. 2. Install the oil pump sprocket.
6. 3. Apply a thin coat of engine oil to the seating
7. surface of the nut.
8. 4. Tighten the nut to the specified torque.
9. Tightening torque: 54 ± 5 N·m

Source: manual:Mitsubishi-2.0L-2.4L-Service-Manual-106992-Revision-D.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.