Mitsubishi — <<B>> OIL PUMP SPROCKET REMOVAL

A Mitsubishi service procedure — check it applies to your exact model before use.

Browse Mitsubishi generators & specs →

Procedure

1. 1. Remove the plug on the left side of the cylinder
2. block.
3. 2. Insert a Phillips screwdriver (shank diameter 8
4. mm) through the plug hole to block the left
5. counterbalance shaft.
6. 3. Loosen the nut and then remove the oil pump
7. sprocket.

Source: manual:Mitsubishi-2.0L-2.4L-Service-Manual-106992-Revision-D.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.