Mitsubishi — INSTALLATION

A Mitsubishi service procedure — check it applies to your exact model before use.

Browse Mitsubishi generators & specs →

Procedure

1. 2. Tighten the camshaft sprocket bolt to the
2. specified torque.
3. Tightening torque: 88 ± 10 N·m
4. >>B<< SPACER INSTALLATION
5. 1. Apply a thin coat of clean engine oil to the lip
6. area of the oil seal.
7. 2. Install the spacer with the chamfered end facing
8. toward the oil seal.
9. >>C<<COUNTERBALANCE SHAFT SPROCKET
10. 1. Install the counterbalance shaft sprocket and
11. screw on the bolt.
12. 2. Install special tool Sprocket stopper (800404) as
13. shown in the illustration to lock the counterbalance
14. shaft.
15. 3. Tighten the bolt, and then remove the special
16. tool.
17. Tightening torque: 45 ± 3 N·m
18. 800405
19. 800406
20. 800404
21. 1. Align timing marks on the crankshaft sprocket
22. "B" a
23. nd counterbalance shaft sprocket with the
24. marks on the front case.
25. 2. Install the timing belt "B" on the crankshaft

Source: manual:Mitsubishi-2.0L-2.4L-Service-Manual-106992-Revision-D.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.