Mitsubishi — Procedure 5

A Mitsubishi service procedure — check it applies to your exact model before use.

Browse Mitsubishi generators & specs →

Procedure

1. 2. Loosen the tensioner "B" bolt, and then remove
2. the timing belt "B."
3. <<F>>COUNTERBALANCE SHAFT SPROCKET
4. REMOVAL
5. 1. Set special tool Sprocket stopper (800404) as
6. shown to prevent the counterbalance shaft
7. sprocket from turning together
8. 2. Loosen the bolt and remove the sprocket.
9. 800424
10. 800399
11. 800404
12. 1. Set special tool Crankshaft sprocket puller
13. (800399) as shown in the illustration.
14. 2. Screw in the center bolt of the special tool to
15. remove crankshaft sprocket "B."
16. <<H>> CAMSHAFT SPROCKET REMOVAL
17. 1. Using special tools to prevent the camshaft
18. sprocket from rotating.
19. 2. Remove the camshaft sprocket.
20. 800399
21. 800405
22. 800406
23. 1. Hardening of rubber backing.
24. Back side should be glossy without resilience and
25. leave no indent when pressed with fingernail.

Source: manual:Mitsubishi-2.0L-2.4L-Service-Manual-106992-Revision-D.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.