Mitsubishi — Service Procedure

A Mitsubishi service procedure — check it applies to your exact model before use.

Browse Mitsubishi generators & specs →

Procedure

1. 4. Unclamp the auto-tensioner from the vise.
2. 800424
3. 5. Install the auto-tensioner onto the front case
4. and tighten to the specified torque.
5. Note: Leave the wire installed in the auto-
6. tensioner. Tightening torque: 24± 3 N·m
7. >>H<< TIMING BELT INSTALLATION
8. 1. Align the timing mark on the camshaft sprocket
9. with the timing mark on the rocker cover.
10. 2. Align the timing mark on the crankshaft sprocket
11. with the timing mark on the front case.
12. 3. Align the timing mark on oil pump sprocket with
13. its mating mark.
14. 4. Remove the plug on the cylinder block and
15. insert a Phillips head screwdriver (shank diameter
16. 8 mm) through the hole.
17. If it can be inserted as deep as 60 mm or more,
18. the timing marks are correctly aligned.
19. If the inserted depth is only 20 to 25 mm, turn the
20. oil pump sprocket one turn and realign the timing

Source: manual:Mitsubishi-2.0L-2.4L-Service-Manual-106992-Revision-D.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.