Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›INSTALLATION

Mitsubishi — INSTALLATION

A Mitsubishi service procedure — check it applies to your exact model before use.

Browse Mitsubishi generators & specs →

Procedure

  1. 2. Tighten the camshaft sprocket bolt to the
  2. specified torque.
  3. Tightening torque: 88 ± 10 N·m
  4. >>B<< SPACER INSTALLATION
  5. 1. Apply a thin coat of clean engine oil to the lip
  6. area of the oil seal.
  7. 2. Install the spacer with the chamfered end facing
  8. toward the oil seal.
  9. >>C<<COUNTERBALANCE SHAFT SPROCKET
  10. 1. Install the counterbalance shaft sprocket and
  11. screw on the bolt.
  12. 2. Install special tool Sprocket stopper (800404) as
  13. shown in the illustration to lock the counterbalance
  14. shaft.
  15. 3. Tighten the bolt, and then remove the special
  16. tool.
  17. Tightening torque: 45 ± 3 N·m
  18. 800405
  19. 800406
  20. 800404

Tools required

  • 6. With your index finger, press the midway of
  • 2. Install special tool Sprocket stopper (800404) as
  • wrench

Specs & torque values

  • 10 N·m
  • 5 N·m
  • 162N·m

Source: manual:Mitsubishi-2.0L-2.4L-Service-Manual-106992-Revision-D.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.