Mitsubishi — Inspect

For these Mitsubishi models: S6R S6R2, S6R- S6R2.

Applies to: Mitsubishi S6R S6R2

Procedure

1. Loosen the two bolts securing the shaft lock plate and remove the plate from the shaft (groove). Then, push in the shaft all the way to the TURN position.
2. Put a socket to the hexagonal end of the y shaft and turn the shaft with a ratchet handle 0 for turning. Bolt
3. After turning the engine, pull the shaft back to Shaft At operation the RUN position, secure the plate with the shaft and tighten the plate bolts. Make sure J the plate i d properly. e plate is secured properly. Socket {/A\ CAUTION }——— 6) Before starting the engine, make sure the Ratchet At turing turning gear is in the RUN position. handle \ / 42 MAINTENANCE SECTION [FUEL SYSTEM] (- ~ Fuel Tank Drain water and sediment {4\ DANGER }—— * Keep maintenance area is safe — no fire hazards. - Completely wipe off any spilled fuel. Spilled fuel is a fire hazard. Open the fuel tank drain valve and allow water and sediment to drain in a container. Drain at least 1 to 2 liters [0.3 to 0.5 U.S. gallons] of fuel to remove water and sediment. New Fuel Filter (Cartridge Type) Filter Change
4. Clean the area to keep the dirt out of the filter base. Old
5. Allow the fuel to drain in a container. Filter
6. Using a filter wrench, remove the used filter.
7. Clean the gasket of a new filter.
8. Coat the gasket of a new filter with clean Goat gasket with . clean diesel fuel. diesel fuel.
9. Clean the filter base. Install the new filter by hand. When the gasket contacts the base, tighten 3/4 to 1 turn more by hand. Do not use the filter wrench in order to avoid damaging the cartridge.
10. Prime the fuel filter.

Source: manual:Mitsubishi S6R Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.