Mitsubishi — Adjusting injection pressure
Adjustments · Fuel injection nozzle
From a Mitsubishi service manual — check it applies to your exact model before use.
Applies to: Mitsubishi S16R engine
Before you start
- Never touch spray during testing.
Procedure
- Install nozzle on tester 41091-01500.
- Operate tester handle about 1 stroke per second.
- Observe pressure at which injection begins.
- Remove cap nut, loosen jam nut, turn adjusting screw.
- Tighten jam nut and cap nut, recheck pressure.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Injection pressure: 350 to 355 kgf/cm2 (4977 to 5048 psi) [34.3 to 34.8 MPa]
Full service-parts list: Mitsubishi S16R engine →
Source: Mitsubishi service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.