Military MEP — Stopping Procedure
Operation · Engine / EMCP
From a Military MEP operator's manual — check it applies to your exact model before use.
Browse Military MEP generators & specs →
Before you start
- Ensure load removed before engine shutdown.
Procedure
- Set AC CIRCUIT INTERRUPTER switch to OPEN to remove load.
- Set ENGINE CONTROL switch to COOL DOWN/STOP (5-minute no-load cooldown).
- Set ENGINE CONTROL switch to OFF/RESET.
- Perform all AFTER PMCS requirements.
- Set DEAD CRANK SWITCH to OFF.
- Set Battery Disconnect Switch to OFF.
Specs & values
- Cool down at no load for 5 minutes
Source: Military MEP operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.