Magnum MTP6000S3 — Towing the Trailer
Operation
For the Magnum MTP6000S3, from the Magnum operator's manual.
Applies to: John Deere PE4024HF285 engine
Before you start
- Never tow the trailer using defective parts.
- Attach breakaway cable to the rear bumper of the towing vehicle, not the trailer hitch.
Procedure
- Raise rear leveling jacks; release jack locking pins and rotate jacks into travel position.
- Use tongue jack to raise or lower trailer onto hitch; lock hitch coupling and attach safety chains/cables.
- Release jack locking pin and rotate jack into travel position; ensure locking pin snaps into place.
- Connect trailer wiring to tow vehicle; check stop and signal lights.
- Check trailer tire inflation and tighten or replace loose or missing wheel lugs in the specified sequence.
- Maximum highway towing speed 45 mph (72 km/h); off-road not to exceed 10 mph (16 km/h).
Tools required
- Torque wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Wheel lug torque: first pass 20-25 FridayParts $42.95 ft-lb (27-33 Nm); second pass 50-60 FridayParts $15.68 ft-lb (67-81 Nm); third pass 90-120 FridayParts $377.99 ft-lb (122-162 Nm)
Source: Magnum operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.