Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Magnum›Stopping the Pump

Magnum MTP6000S3 — Stopping the Pump

Operation · Engine

For the Magnum MTP6000S3, from the Magnum operator's manual.

Applies to: John Deere PE4024HF285 engine

Before you start

  • If the pump is to remain idle during below freezing conditions, drain the pump to prevent freeze damage; clean out solids by flushing with a hose.

Procedure

  1. Reduce engine speed by adjusting the Speed Control switch.
  2. Allow the engine to idle briefly.
  3. Switch the Engine Start switch to the OFF position.

Source: Magnum operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Magnum repair guides →