Magnum MTP6000S3 — Before Servicing the Pump
Maintenance
For the Magnum MTP6000S3, from the Magnum operator's manual.
Applies to: John Deere PE4024HF285 engine
Before you start
- Attach a DO NOT START sign to the control panel.
- If the pump handles hazardous materials, wear approved protective clothing and use appropriate safety equipment.
- Never wash the unit with a high pressure hose or power washer.
Procedure
- Verify the Engine Start switch is turned to OFF and the negative battery cable is disconnected.
- If the pump or components are hot, allow adequate cooling prior to servicing.
- Close the suction and discharge valves, if applicable.
- Vent the pump slowly and drain completely.
Source: Magnum operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.