Magnum MLT4200IF4 — Raising the Mast
Operation
For the Magnum MLT4200IF4, from the Magnum operator's manual.
Applies to: Magnum MLT4200IF4, Isuzu 4LE2TAGV-03 engine
Before you start
- Never raise or lower the mast while the unit is operating
- Stop immediately if the winch cable develops slack or a mast section sticks
Procedure
- Set up and level the unit with outriggers extended
- Remove the mast cradle locking pin
- Check mast cables and electrical cord for wear or damage
- Clear the area around the unit before raising the mast
- Remove the safety pin from the mast lock bar and raise the mast with the lower winch until it locks; reinsert the safety pin
- Telescope the mast to desired height with the upper winch, watching the electrical cord
- Rotate the mast to the desired direction and tighten the rotation knob
Full service-parts list: Magnum MLT4200IF4 →, Isuzu 4LE2TAGV-03 engine →
Source: Magnum operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.