Kubota WG972-GL-E3F — Replacing Radiator Hoses and Clamp Bands
Maintenance
For the Kubota WG972-GL-E3F, from the Kubota service manual.
Browse Kubota generators & specs →
Before you start
- Do not remove the radiator cap when the engine is hot.
Procedure
- Drain the coolant.
- Loosen the clamp bands.
- Remove the upper hose and lower hose.
- Replace new upper / lower hose and clamp bands.
- Tighten the clamp bands.
- Fill with clean water and anti-freeze until the coolant level is just below the port. Install the radiator cap securely.
Source: Kubota service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.