Kubota WG972-GL-E3F — Replacing Oil Filter Cartridge
Maintenance · Engine oil filter cartridge
For the Kubota WG972-GL-E3F, from the Kubota service manual.
Browse Kubota generators & specs →
Before you start
- Be sure to stop the engine before changing filter cartridge.
- Over tightening may cause deformation of rubber gasket.
- Use only a KUBOTA genuine filter or its equivalent.
Procedure
- Remove the oil filter cartridge with the filter wrench.
- Apply a slight coat of oil onto the new cartridge gasket.
- Install the new cartridge; screw it in by hand.
- Check that engine oil does not leak and read the oil level on the dipstick, then fill to specified level.
Tools required
- Filter wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Kubota service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.