Kubota — Injection Timing
Adjustments · Fuel injection pump
From a Kubota service manual — check it applies to your exact model before use.
Browse Kubota generators & specs →
Procedure
- Remove the injection pipes and nozzle.
- Set the speed control lever to maximum fuel discharge position.
- Turn the flywheel counterclockwise until fuel fills the delivery valve holder hole for 1st cylinder.
- Turn the flywheel further and stop when the fuel begins to flow over.
- Calculate the angle the center of the window points out; add or remove the shim to adjust.
Tools required
- Screwdriver Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Injection timing [D1403 FridayParts $9.50 SinoCMP $79.00/D1503 FridayParts $11.00 SinoCMP $79.00 KuduParts $99.00/D1703 eBay FridayParts $8.95 KuduParts $99.00 SinoCMP $119.00/V1903 FridayParts $10.50 SinoCMP $139.00/V2003-T FridayParts $9.88 SinoCMP $95.00/V2203-E2B FridayParts $309.99]: 0.297 to 0.331 rad (17 to 19°) before T.D.C.
- Injection timing [F2803-E2B]: 0.314 to 0.349 rad (18 to 20°) before T.D.C.
- Shim thickness addition/reduction of 0.05 mm changes timing by approx. 0.0087 rad (0.5°)
Source: Kubota service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.