Kohler TP 4.0 D — Install Mobility Kit
Installation
For the Kohler TP 4.0 D, from the Kohler owner's manual.
Browse Kohler generators & specs →
Before you start
- Place blocks underneath to raise pump to install wheels and legs.
Procedure
- Insert rubber bumper into cross member hole at center; place axle brace onto cross member and bumper, angled up.
- Insert washer and thread nut to rubber bumper; tighten loosely.
- Assemble cross member assembly to frame; install screws through frame and cross member with washer and locking nut; tighten loosely.
- Align middle hole in axle to axle brace; install screw through axle and axle brace with washer and locking nut; tighten loosely.
- Align holes in axle to frame; install screws through frame and axle with washer and locking nut; tighten loosely.
- Torque all nuts to 120 in. lb. (13.6 N.m); tighten axle and axle brace locking nut first.
- Install wheels onto axle, push retaining rings onto axle.
- Align handle with holes on frame; install screw with washers through handle into frame.
- Place curved spacer on opposite side of frame; place another washer outside handle and thread nut on.
- Tighten screws enough to allow handle to move free.
Tools required
- torque wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Torque all nuts to 120 in. lb. (13.6 N.m)
Source: Kohler owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.