Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Starter Reassembly

Kohler — Starter Reassembly

A Kohler service procedure — check it applies to your exact model before use.

Browse Kohler generators & specs →

Before you start

  • Do not lose springs
  • Do not damage commutator or armature

Procedure

  1. d. 4. New brushes and springs come preassembled in a brush holder with a protective sleeve that will also serve as an installation tool. 5. Perform Steps 10-13 in
  2. a. Install stop collar down onto armature shaft with counter bore (recess) up.
  3. b. Install a new retainer in larger (rear) groove of armature shaft. Squeeze with a pliers to compress it in groove.
  4. c. Slide stop collar up and lock it into place, so recess surrounds retainer in groove. If necessary, rotate pinion outward on armature splines against retainer to

Tools required

  • Brush installation tool

Source: manual:Kohler Command Pro Service Manual CV682-752 24_690_37_EN.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.