Kohler — Set Float Level
Adjustments · carburetor
From a Kohler service manual covering: K141, K161, K181, K241, K301, K321, K341, K91. Check it applies to your exact model before use.
Browse Kohler generators & specs →
Procedure
- Invert carburetor so float tab rests on fuel inlet needle.
- There should be 1/64 in. (±1/32 in.) clearance between machined surface and free end of float.
- Bend float tab with small screwdriver to adjust.
- Turn carburetor to normal operating position for float drop.
- Float drop should be limited to 1-1/32 in. between machined surface and bottom of free end of float.
- Bend float tab to adjust.
Tools required
- small screwdriver Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Float level 1/64 in. ±1/32 in.
- Float drop 1-1/32 in.
Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.