Kohler — Service Reconnect Procedure, Service Disconnect to OFF (Normal source available)

Maintenance · Transfer switch

From a Kohler service manual — check it applies to your exact model before use.

Browse Kohler generators & specs →

Procedure

1. Remove the padlock and move the service disconnect switch to AUTO.
2. Reset faults on the controller, if necessary.
3. The ATS transfers to normal source.
4. Verify the controller shows normal source available and ATS in normal position.
5. Confirm the Utility Disconnected light on the door is off.

Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Kohler repair guides →