Kohler — Secondary Clutch Service
Repair & overhaul
From a Kohler service manual — check it applies to your exact model before use.
Applies to: Kohler LH775 engine
Before you start
- Do not lubricate clutch components during assembly.
Procedure
- Make alignment marks on cam assembly, moveable sheave and stationary sheave.
- Remove four torx screws and remove cam assembly.
- Use secondary clutch press tool to compress spring and remove retaining ring.
- Release press tool; remove outer dampened spider, dampener, insert, spring and moveable sheave.
- Inspect spring, rollers and sheave contact surfaces; replace if worn.
- Reassemble in reverse; align X marks during last 1/2 in of spring compression.
- Secure cam with four torx screws and torque 8 to 12 ft-lb (11 to 16 N-m).
Tools required
- Secondary clutch press tool (TOR6027) Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Torx screws 8 to 12 ft-lb (11 to 16 N-m)
Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.