Kohler RXT-JFNC-0400 — Transfer Switch Wall Mounting
Installation
For the Kohler RXT-JFNC-0400, from the Kohler service manual.
Browse Kohler generators & specs →
Before you start
- Disconnect all power sources before opening the enclosure
- Do not use compressed air to clean the switch
Procedure
- Mount transfer switch to wall or other rigid vertical supporting structure
- Refer to dimension drawings in Section 6 for hole locations; use shims to plumb enclosure
- Cover or remove internal components to protect from drill chips or debris
- Tighten mounting screws to 2.9 Nm (26 in. lb.) when reinstalling components
- Use washers with mounting screws on NEMA 3R gasketed mounting holes
Tools required
- vacuum cleaner Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- 2.9 Nm (26 in. lb.) mounting screw torque
Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.