Kohler — Procedure to Clear a Module Status Conflict
Maintenance · Accessory module
From a Kohler service manual — check it applies to your exact model before use.
Browse Kohler generators & specs →
Before you start
- Disconnect all power sources before opening the enclosure.
Procedure
- Disconnect power to the transfer switch.
- Disconnect the module.
- Close the enclosure door and reconnect power to the ATS; display shows Module Status Change.
- Press Reset; display shows Check Module Setup to Clear Fault.
- Follow Section 1.11.1 to uninstall the module through the controller keypad.
- Disconnect power to the ATS.
- Connect the new module, close the door, reconnect power, press Reset.
- Navigate to the Set Auxiliary I/O menu to check the new module status and settings.
Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.