Home›Repair guides›Kohler›Oil Change/Oil Filter Change

Kohler — Oil Change/Oil Filter Change

Maintenance · Lubrication system

From a Kohler service manual covering: 7CCFKM, 7CCFKM / 7CCFKMR, 7CCKM, 7CCKM / 7CCKMR. Check it applies to your exact model before use.

Applies to: Kohler 7CCFKM, Kohler 7CCKM, Kohler K-582 engine

Before you start

  • Wash hands after any contact with engine oil
  • Do not pollute the environment; dispose of used oil properly

Parts for this job

Part numbers from the service-parts lists for Kohler 7CCFKM, Kohler 7CCKM. Verify against your serial number before ordering; some links are affiliate links.

Procedure

  1. Drain oil warm by opening petcock right of dipstick; allow full drain then close.
  2. Remove filter counterclockwise with oil filter wrench; discard properly.
  3. Clean contact surface of oil filter adapter.
  4. Apply light coat of fresh oil to filter rubber seal.
  5. Thread filter to adapter until gasket contacts, hand-tighten one-half turn more.
  6. Refill with 4 U.S. Quarts (3.8 L) of proper oil.
  7. Start set, check for leaks at petcock and filter; stop and recheck level.

Tools required

Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.

Specs & values

Full service-parts list: Kohler 7CCFKM →, Kohler 7CCKM →

Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Kohler repair guides →